Hi all, if you have a copy of TRF's parts catalogs, check page #38 in the blue
book, and you'll find a picture of the cap, with the part# of the seals for
the various years on the following page. Part # 725220, which fits years '72
thru '76, lists for $8.95 in the blue price list, which I think is still
current. The other part #s listed supercede to the 725220 part number. HTH
Greg Donegan
72 TR6 CC82492U
Hebron, KY
----- Original Message -----
From: James A. Tabor
Sent: Wednesday, October 03, 2001 5:12 PM
Cc: 6pack@autox.team.net; triumphs@autox.team.net
Subject: Re: Gas lid seal
Hi,
On late model TR6's (and probably early ones as well) there
is a 'plug' shaped rubber seal which sits under the cap lid.
it is held in place by a lip that stretches over a round
shaped (spring loaded?) disk.
so when the cap is closed and latched the rubber plug (appropriately)
plugs the hole on the bottom part of the cap...which is the
filler neck (the filler hose and gas tank are below)
there is a body grommet, but that protects/seals the hole in the body deck
and the filler cap assembly goes into the grommet.
Am I articulating clear? trying to explain w/o hand motions! ;-)
-james
>From: jay_welch@juno.com
>To: skip@pobox.com
>CC: jatabor@hotmail.com, 6pack@autox.team.net, triumphs@autox.team.net
>Subject: Re: Gas lid seal
>Date: Wed, 3 Oct 2001 15:26:25 -0400
>
>No, I'm talking about the seal at the fill hole itself. I'll have to
>look closer. I'm actually asking for a friend but I thought I remembered
>a rubber seal. I'll have to put my specs on tonight and take a closer
>look at mine. Thanks for the feedback.
>
>Jay
>
>On Wed, 3 Oct 2001 14:24:09 -0500 Skip Montanaro <skip@pobox.com> writes:
> >
> > >> Does anyone know who might stock the rubber seal where the
> > TR6 fuel
> > >> cap meets the fill hole?
> >
> > Are you talking about the seal between the body and the filler pipe?
> > I
> > bought one of those a couple years ago, probably from TRF or Moss.
> > My
> > TR-250 has no seal between the cap and the filler pipe, however.
> > Just a
> > magnet on the inside of the gas cap proper holds it to the filler
> > pipe. Did
> > this change (perhaps to meet stricter fuel vapor requirements)
> > during the
> > TR6 run?
> >
> > --
> > Skip Montanaro (skip@pobox.com)
> > http://www.mojam.com/
> > http://www.musi-cal.com/
_________________________________________________________________
|