| To: | RSH17@msn.com (Richard Seaton) |
|---|---|
| Subject: | Re: to little crankshaft end float? |
| From: | tr6taylor@webtv.net (Sally or Dick Taylor) |
| Date: | Fri, 31 Aug 2001 23:51:25 -0700 (PDT) |
Richard---I didn't see this message before answering your other one. If the engine has ran for 15,000 miles with only .001 clearance for crank float I would be a little surprised, but not disbelieving! Just be sure you're levering the crank back, then forth, and your dial indicator is solidly placed. (.005 is a better end float) Dick |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Next by Date: | lower trunion bolts, Walt Philipson |
|---|---|
| Next by Thread: | RE: to little crankshaft end float?, Walt Philipson |
| Indexes: | [Date] [Thread] [Top] [All Lists] |