>Dear listers,
>
> While re-bushing the front end on my car, I noted the following, It seems
>possible to mix up the position of the upper wishbone halves from front to
>rear, and or from driver to passenger side. I suspect that this may have been
>done by the previous owner, so I do not simply won't to re-install the
>components as I found them. After studying several depictions of the upper
>wishbone in the Bentley and parts catalog, I cannot tell where the wishbone
>halves really belong, I know the front and rear items are not interchangeable,
>as there are separate #s in the parts book. However, I can't tell which is
>which. I also suspect that there is a difference between the driver and
>passenger side, as I found an R and an L stamped in 2 of the four pieces.
>Does anyone have experience with this problem? Thanks in advance.
>
>Best Regards,
>Joseph Garruba
The top front wishbones are handed and stamped L and R. When fitting
the L/H the L should appear on the upper surface.
Hope that helps,
--
William Davies
1975 TR6 PI
CR6157-O
|