Re: Fine tuning the carbys

[RodsINTOMG@aol.com]

In a message dated 3/21/00 7:09:40 PM Pacific Standard Time, 
thomkuby@iwvisp.com writes:

<< 
 In order to completely lean the carbs out - you turn the nut (on the base
 of each carb) completely counterclockwise (to close 'em)?
 and then you turn clockwise, a "flat at a time", until you get the right
 mix? is this right? >>

Thom,

I think you have it backwards.  Turn the jet adjusting nut clockwise (to the 
right) to lean and counterclockwise (to the left) to richen.

Rod Schweiger