>
> I don't have a notched plug, so I shouldn't need that scary
> socket. I tried a 32mm socket, too big, and a 30mm socket,
> too small. So I'll see if I can find goldilocks somewhere
> tomorrow. Hate put a pipe wrench on it, last option.
I got curious, so I did some checking. Looks like maybe the original intention
was 11/16 Whitworth, which according to the chart I
have is 1.200". The socket I used was 30mm, which should be only 1.181" but
it's a bit oversize and actually measures about 1.195".
It will go onto the old plug I found (not the same one I was using before) with
some persuasion. Since the plug is somewhat chewed
up (looks like someone has been at it with a cold chisel), the 30mm impact
socket would still be the right tool, IMO, even if I had
to clean up the flats a bit with a file.
Probably none of that helps, I was just wondering WTF? If you can't get the
30mm on with some encouragement, maybe pick up a big
adjustable wrench.
Randall
** triumphs@autox.team.net **
Archive: http://www.team.net/archive
|