[TR] question about hub stud installation

["Pete Ryner" <pryner@verizon.net>]

I had to replace two rear hub studs on my '56 TR3.  It looked like they were 
pressed in but I found that they are screwed in then peened over on the back 
of the hub.  I don't think I will be able to peen the new studs with simple 
shop tools.  Any suggestions or alternative methods?  I was thinking about 
high strength locktite??
TIA
Pete 

** triumphs@autox.team.net **

Archive: http://www.team.net/archive