triumphs
[Top] [All Lists]

[TR] gearbox

Subject: [TR] gearbox
From: nafzigerg at yahoo.com (Gary Nafziger)
Date: Wed, 12 Jan 2011 11:33:36 -0800 (PST)
I'm dealing with the tr-3 gearbox from hell.  It's not the early non-synchro 
gearbox but not sure how much later of a gearbox it is.  Might be a tr-4.  Most 
of the problems I've had so far are just neophite beginner non mechanic 
mistakes.  (buttoning it all up only to find three little balls and springs 
laying on the workbench....grrrrrr)  


Anyway at present I'm having a huge problem getting the middle big bearing (the 
one at the end of the gear box, not the one on the end of the tailshaft) beat 
onto the shaft far enough to get the washer and circlip on.  I'm within 1/16 of 
an inch but can go no farther.  I've stood the gearbox up on end with a block 
under the mainshaft on bell housing end then tried to drive the bearing down 
the 
shaft to no avail.  I'm afraid I'm gonna break something.  Getting the bearing 
into the gearbox case is not the problem......its getting the bearing down the 
shaft.  I took everything out and on the bench vice was able to get the bearing 
down the shaft to the appropriate place.............If anyone has been there 
done that..........advice would be appreciated.  


One big piece of advice to anyone contemplating gearbox work.  If it works 
DON'T 
touch it.LOL  This gearbox was fin untill I started working on it,  as i found 
everything pretty much measured to specs.  I did change the counter shaft 
thrust 
washers but prolly didn't need to. 

thanks!

gary n.



      

<Prev in Thread] Current Thread [Next in Thread>