Pat,
I think the TR radiator shrouds were made when wet. You could soak
your's in a tub, carefully clean with soft bristle brush - but most
importantly pre-figure a drying jig (so it dries and hardens in proper
form) BEFORE the big soak.
But I think I might simply sponge it off with mild soap and water, let
it dry square, or install it, tweak it's form, and let it dry
perfectly fitted in place. Then when dry, remove, paint it, waterproof
it, or whatever..
Good luck,
Carl
'63 TR4 since 74
> I just purchased and received a TR4A shroud/duct for the radiator,
> used
> of course. The duct is in fairly good shape for something that's been
> around
> for over 40 years. There is noticeable rust on the rivets, and it's
> dirty
> with black soot-like material that comes off on the hands while
> handling. How
> do I clean this duct to prepare it for painting? I googled "cleaning
> cardboard" and found a link for cleaning cardboard game board boxes.
> The
> suggestion was to immerse the box in a tub of lukewarm water and then
> let dry,
> thoroughly. I don't think I want to do this with the duct.
> Thanks for any
> suggestions,
> Pat
> TR4A '67
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|