> 1. Bottom waist seal: This is a slide on seal that has the wide round
> section to one side. Does the wide round part go to the inside or the
> outside?
Wide round part goes to the inside, rests against the car body.
> 2. Front top to windscreen seal: Does the rubber seal on the top of the
> windscreen remain?
Yes, although it gets cut to fit around the HT brackets.
> There doesn't seem to be space for both it and the
> seal that goes to the top front of the hard top.
The HT seal should have a channel shape to it, and fits over the seal on the
windscreen frame; with the sides of the 'channel' to the front & rear of the
rounded seal on the windscreen. Here's a diagram from the factory workshop
manual, that kind of shows how they fit together.
Randall
[demime 1.01d removed an attachment of type image/jpeg which had a name of
untitled.jpg]
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|