Friends,
I am trying to replace the seals on my TR6 stub axles. I am trying to pull the
bearings off in the directions of the axle splines. This, hopefully, will
enable me to remove the carrier that holds the seal so I can replace it. I am
unable to get the bearing off using this method. It moves about an eighth of an
inch and seems to be getting blocked on a minor lip. Am I doing it wrong? Does
heat need to be applied? I am trying to avoid pulling the flange but will if
that is the only way to do it. Responses from anyone who has been there and
done that there will be greatly appreciated.
Doug Nelson
Washington, GA
74TR6
________________________________________
PeoplePC Online
A better way to Internet
http://www.peoplepc.com
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|