---- Will Daehler <wdaehler@wi.rr.com> wrote:
> Onto the topic, I was checking out my car, and noticed the vacuum advance
> line was broken again, right where it mounts under the SU carburetor.
>
> Anyway, is there anyway to repair this and avoid the gouge? Do I need a
> two-fisted bubble flaring tool?
I was feeling so smug about my driving adventures, I forgot to answer the
question...
I'm not positive, but I think that's just a standard compression fitting,
available at any good hardware store. slip the bead over the tubing, and
tighten it up.
Jeff Scarbrough
Athens, Ga.
Flying Formations Of Rust
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs@autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
http://www.team.net/archive
|