-------------- Original message --------------
From: "Wages, Jeffrey (CDC/CCID/NCID)" <bzw8@cdc.gov>
> Hi all,
>
> As I went to install a new (but used) roll bar in my TR6, I discovered
> that the over the shoulder inertia seatbelt housings would not allow the
> roll bar to be installed. I assume that they must go or be moved and I
> wondered if anyone knew what the best, tried and true, option may be.
>
> Any ideas?
The best tried and true option is to find the roll bar designed to fit a TR6
that has its uprights curved inwardly in order to clear the seat belt reels.
Such a bar exists.
Irv Korey
74 TR6 Cf22767U
Highland Park, IL
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|