triumphs
[Top] [All Lists]

RE: carpet installation

To: "'Mitchel Seff'" <ms6453@optonline.net>, "'6-Pack email list'" <6pack@autox.team.net>, "'Triumphs@Autox Net \(E-mail\)'" <triumphs@autox.team.net>
Subject: RE: carpet installation
Date: Sun, 1 Aug 2004 20:51:08 -0400
Mitch,

The original carpet sets had snaps on the footwells, over the
transmission hump as well as the  driveshaft tunnel. Most folks, me
included don't bother with the trans. tunnel and driveshaft tunnel snaps
because there is no real need for them. The original male snaps on the
tunnels were screwed in and were longer than the male snaps on the
floor. I assume this was to fit over the heavy jute underlayment.  
The carpet kits I've received from TRF had instructions. Either yours
were inadvertently omitted or they have changed their policy. Call Dave
at TRF and see if he can get a set of instructions for you. Of course,
if your existing carpet is installed properly, you don't really need
instructions, just replace the new as the existing carpet.

Jim Davis
Fortson, GA
CF38690UO
 




Hi all,

I received my TRF carpet set & need a few installation tips. The old 
carpet set only had snaps for the footwell carpets, all the others just 
laid in place. Should the rear deck, trany tunnel & fire wall sections 
be snapped in place. I'm surprised not a single piece of paper 
describing the installation or tips came with the carpet set. Products 
costing far less & much simpler to install come with some sort of 
instructions (take note TRF ).
Thanks,

-- 
Mitch Seff
Oceanside, N.Y.
75 TR6





<Prev in Thread] Current Thread [Next in Thread>