Replace with new. Failing that, immerse it in hot water, rotate it and
watch for a stream of bubbles. circle the spot with a pencil and
alternatly heating it and allowing it to cool use the expanding
internal gas pressure to push the gas out the pin hole. Don't use a
candle or match as your heat source though. Once it's empty, seal the
hole.
On Friday, May 28, 2004, at 10:49 AM, Triumphs@Autox.team.net daily
digest wrote:
> Subject: Re: TR3A Carburator question
>
> Randall Young wrote:
>
>> While you're at it, fish out the float. Shake it to check for fuel
>> inside.
>>
> And what is the best remedy if there is fuel in there?
|