Re: TR6 accelerator pedal bushings

[Joe Sholtes IV <joeiv@snet.net>]

Dave B. Hammond wrote:

>Try putting them in a pay of hot water to make them as pliable as possible;
>then use a screwdriver to put in the holes, a bit at a time.
>
Dennis,

  Make that boiling hot water (microwave oven with bushings in the water)
in a coffee cup- or a pay- if you know what that is ;^)   Use plenty of 
spray
silicone lubricant too.  It is not an easy job, but keep at it, it is 
possible

                                                 JOE IV
                                                  TR 250
                                            WALLINGFORD, CT. USA

///  triumphs@autox.team.net mailing list
///  To unsubscribe send a plain text message to majordomo@autox.team.net
///  with nothing in it but
///
///     unsubscribe triumphs
///
///  or try  http://www.team.net/cgi-bin/majorcool