David,
I just went and measured mine which is original equipment.
The bracket is approx. 8 3/4 inches from the water pump attachment to the center
of the bracket. The bracket is 3 " long from the center of the pipe to the end
of
the bracket. The bracket is only about 1/4 inches below the coil bolt. It is 2
5/8" from the center of the coil bolt to the center of the pipe. The bracket is
not bent at all.
I hope these measurements help out
David Templeton wrote:
> Hi all,
>
> I am trying to install the water pipe from the pump (635-140). In test
> fitting it, the bracket doesn't seem to line up to the coil mount like I
> figure it should. The bracket appears to be 3/4" longer than needed. Is this
> right? Does it need to be bent? I have the wrong part? Do I simply drill a
> new mount hole?
>
> Thanks
> David A. Templeton
> '59 TR3a
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
/// or try http://www.team.net/cgi-bin/majorcool
|