Hmm, now that you mention it, that does sound a little too slick.
However, _I_ didn't write that, I wrote a reply about using Acryli-clean
instead of lacquer thinner.
Randall
(randallyoung@earthlink.net when I'm at home <g>)
> -----Original Message-----
> From: TexasTR4@aol.com [mailto:TexasTR4@aol.com]
>
> In a message dated 04/22/2000 12:07:20 PM Mountain Daylight Time,
> randallyoung@earthlink.net writes:
>
> > I sanded the bare metal with 400, then 600,
> > > and finally 800 grit, then cleaned with lacquer thinner.
> I sprayed on
> the
> > > gray primer. Then I sprayed the black top coat. I
> allowed the wheel to
> > dry
>
>
> A late repy I know...just got home , but isn't a rougher
> surface needed for
> adhesion of the primer? I'd sand with 240 grit or so to
> give the primer
> something to hang onto. 800 grit must have made it quite slippery..
>
> RH
>
|