TR6 engine stand

[Jim Davis <jh_davis@mindspring.com>]

        Sorry for the late entry into this one but I'll add my $.02 anyway. I
fit the crank, rear oil seal and rear plate while the engine is on the
bench, then mount the engine on the stand using the rear plate bolt
holes. This allows a bit more room to attach the the engine stand arms
and you can use 2 3/8" bolts. It's also easier to balance the engine on
the stand with the crank installed. I use grade 8 bolts for peace of
mind.  

Jim Davis
Fortson, GA
CF38690UO
CF37325U