What a great idea ! Wish I'd thought of that ... <g>
On Thursday, May 06, 1999 4:46 AM, fogbro1@impop.bellatlantic.net
[SMTP:fogbro1@impop.bellatlantic.net] wrote:
>
> FWIW I always fit the throttle stop castings in two steps.
>
> 1. I install the shafts and butterflies, carefully centering the
> butterflies by wiggling, jiggling and holding them up to bright light to
> minimize any gap between them and the bodies.
>
> 2. I fit the castings onto the shafts with Locktite blue or red making
> sure they're positioned so that I have both idle adjustment at the
> closed position and butterflies perpendicular to the passage at the
> fully open position.
>
> 3. After the Locktite has set, I disassemble the shafts and butterflies,
> drill the holes and insert roll pins. Now I know that the throttle stop
> castings will be in the correct position when I reassemble the carbs.
>
> Ed Woods
>
>
|