At 8:39 PM -0000 26/12/98, Martin Gonzales wrote:
>I am installing kits in both master and slave clutch units and would like
>to replace the existing bleeder nipple in the slave unit with a speed
>bleeder. However, since I am trying to buy the speed bleeder locally, I
>need to know the size of the speed bleeder.
>
>Thanks in advance
>
>Martin
>73 TR6
>San Jose, CA
The information that I have been given is:
Clutch 7/16th inch x 20 - SB71620
Front brakes (pre 1971 - imperial) 3/8th inch x 24 - SB3824
Front brakes (post 1971 - metric) 10 mm x 1.0 - SB1010
(there are several SBs in this size, this is the model recommended by
Speedbleeders when I asked)
Rear brakes (all years) 3/8th inch x 24 - SB3824
This is not based on first hand knowledge, as I am still waiting for the
SBs to arrive so that I can fit the clutch. The SBs for the brakes will go
onto the shelf until I need them. Please feel free to correct me if you
have better information.
This should go in the FAQ.
Trevor Jordan
74 TR6 CF29281U
|