| To: | Neil Penberthy <n.penberthy@liant.com> |
|---|---|
| Subject: | Re: TR 6 Project - piston question. |
| From: | Trevor Boicey <tboicey@brit.ca> |
| Date: | Wed, 14 Oct 1998 18:56:32 -0400 |
| Cc: | triumphs@Autox.Team.Net |
| Organization: | BRIT Inc. |
| References: | <98Oct14.144432cdt.130819@jumpgate.liant.com> |
Neil Penberthy wrote: > I have had the head rebuilt and skimmed a little for extra compression and > I was recently cleaning the pistons and block surface ready for reassembly. > While doing this I noticed clearly marked on all the pistons rear edge > "0.75mm". I'm a little baffled what this means. Any ideas anyone ? 30 thou over pistons, metric sized. (0.25mm is 10 thou) -- Trevor Boicey, P. Eng. Ottawa, Canada, tboicey@brit.ca ICQ #17432933 http://www.brit.ca/~tboicey/ |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re:Stromberg Needle Height, Bud Rolofson |
|---|---|
| Next by Date: | Dan Master's restoration fund, Dave Massey |
| Previous by Thread: | TR 6 Project - piston question., Neil Penberthy |
| Next by Thread: | TR 4A OD in TR250, MPRICE |
| Indexes: | [Date] [Thread] [Top] [All Lists] |