Re: Yet more on Spit front wheel bearing oil seals<961002212741_535617885@emout10.mail.aol.com>

["Richard Jackson - Network Technician ext. 2570"<RICHARD.JACKSON@nene.ac.uk>]

Mornin' All,

>Worldly Scions,

>Well it appears that the list concensus is the felt oil seal
>should be installed facing the vertical link, not the wheel bearing / hub.
>I especially enjoyed mjb's answer & explanation.
            
[snip Bob's bit] Hmmm, perhaps I shoulda wrote that differently :-)

>I took a couple of spares apart and found both orientations.
After all this discussion about felt facing every which way, I thought I'd give
John Kipping a quick ring, apparently, he says that the felt MUST face the
verticle link........looks like I've been doin' it wrong all these years then
:-)

Rich
Northampton
England.