| To: | peterz@merak.com |
|---|---|
| Subject: | Re: TR6 Clutch Shaft Bushings |
| From: | JIMDAV6@aol.com |
| Date: | Sat, 24 Aug 1996 19:37:04 -0400 |
| Cc: | triumphs@autox.team.net |
Peter, While I have always used a bushing remover/installer to tap the clutch shaft bushings into the bellhousing, I believe a 3/8 drive 5/8 long socket will surfice. They come out and go in very easily. I always replace the slave cylinder push rod assy. and both clevis pins when doing a clutch job. You'll be suprised how replacing these items will "tighten up" the clutch linkage. Good Luck, Jim Davis GTA CF38690UO CF37325U |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | AMCO Bumper Bar, muntsb |
|---|---|
| Next by Date: | re: Wire Wheels, 155 Tires, Bruce's TR7, Keith A. Edwards |
| Previous by Thread: | TR6 Clutch Shaft Bushings, Peter Zaborski |
| Next by Thread: | blowers, etc, Randell Jesup |
| Indexes: | [Date] [Thread] [Top] [All Lists] |