AN>The starter motor on my 1956 TR3 has failed. When pushing the starter button
AN>the motor runs willingly, but it doesn't turn the engine.
AN>What is the likely cause of this? Is reconditioning a starter motor for the
AN>average DIY person? If not, does anyone know a good source for reconditioned
AN>/NOS starter motors in Europe? What should I expect to pay?
AN>Thanks,
AN>Anders, Aarhus, Denmark
Anders,
Sounds like front bearing or rear bushing since the motor seems to turn
without a load.
Not a difficult job to replace these parts, however to do the job
correctly and be sure the starter will last, there are some specifics
that should be followed such as resistance in the field coil and the
armature windings. However, if it were me, I would preobably just
replace the bushes and brushes and give it a good cleaning and stick it
back in. Almost sounds too easy.
Best Regards,
Tony
--
The Digital Zone (915) 751-0131 voice (915) 759-8100 data
http://www.dzn.com
|