I'm getting ready to install the interior in my 72 TR6 and am sure I will
have a million questions before I'm done. One problem I have is that I
didn't remove the old it was out when I bought the car. It looks like all
the pieces are there.
My question today is regarding covering the rear wheelarches. I have some
foam pading that came from TRF which is thin and is in two pieces for each
side. It looks like these pieces overlap each other. Should they be left
overlapping or should they be trimmed so that they don't overlap at all?
Should I even use these pieces or should I use some of heaver sound damping
material? Should thes pieces be glued to the wheelarch first and the vinyl
trim piece then glued to these or should they be glued to the vinyl trim
piece first and the assemble glued to the wheel arch? The vinyl trim piece
looks as if it will need to be streched tight to get the wrinkles out from
around the seam for the radius? Is this normal?
Any help in this area will be greatly appreciated!
Thanks,
Ron Olds
72 TR6
60 TR3A
50 TD
|