Please email me a name and address if you or friends are interested in
purchasing a "1996 factory" A/C for your TR6. Cost will be under
$1,000.00 for the complete system:
1. HFC-134a refrigerant
2. New heater/defroster/AC unit with high CFM fan
(replaces heater and attaches to existing wires/controls/ducts)
3. Condenser, pusher fan, thermostat, drier fit inside radiator shroud
4. New high efficiency low HP compressor
5. All hoses/fitting, etc. included, uses existing bulkhead holes
There are NO visible cockpit changes...
--
BACKGROUND:
To my knowledge, no other effort at putting A/C on a TR6 is in progress?
I used to install A/C kits on Jap cars at one time and have researched
the three types of A/C kits fitted to the original TR6's. None of the
original units meet ANY of the above requirements.
---
After 3 months of reseach, I found an A/C factory interested in producing
a TR6 kit.
SCHEDULE:
I visit for a prototype TR6 A/C kit fitting on Tuesday and was told
that they would be VERY, VERY interested in my visit if they could
sell at least 10 kits based on the prototype. So I could have a
complete kit in 30-45 days...
NOTE:
As an aside, they currently produce bolt-on "factory" kits for 55-57 chevy,
mustang, camaro, toyota, corvette
--
-----------------------------------------------------------
Roger G. Bolick, rgb@exact.com, (512) 794-9567, FAX 345-2879
|