TR6 Rear End - UJ's

[mike@ShoppersDrugMart.ca]

Finally got the u-joint out.  Wailed away at it with the sledgehammer for 
and hour and it finally popped out.  Bearings in one of the caps were dry 
and had been ground down to dust.  Always nice to know that kind of effort 
is justified!  Now it's down to pulling the trailing arm bushings... two 
are out thanks to the threaded rod method (a little heat was applied to 
make the job easier) but 1/4" threaded rod has a tendency to snap under 
stress.  Snapped 3 times, in fact, so I think I'll use 5/16 for the next 
attempt ;-)

Mike Himelfarb.