On Aug 14, 11:32pm, Bill Sohl Budd Lake wrote:
> Subject: Re: Removing rear drums on a 250
[snip]
>
> A good substitute for the correct tool is the following: Go to
> Sears and buy a 3/8" 8 point socket for a 1/4" drive. Use the
> 1/4" side (the 4 point side) on the adjuster and use a regular 3/8
> drive on the 8 point side. That'll give you the best contact
> without worrying about the 3/8 socket slipping.
>
> Cheers, ---------------------------------------------------------------
> Bill Sohl K2UNK (Budd lake, New Jersey) (billsohl@planet.net)
> VTR Assistant Magazine Editor, Past VTR President (1983-1990)
> -----------------------------------------------------------------------
>-- End of excerpt from Bill Sohl Budd Lake
Snap-On sells a 1/4" square socket that has a 1/4" drive. I tried to
buy one from Snap-On about 6 years ago, but the Snap-On jobber never
got back to me. Every time I see a MAC tools truck, I think about
stopping and trying to buy one. Maybe I'll just take this suggestion!
Doug Mitchell
|