I am planning to install reversing lamps when the motor and trans are
re-installed in my Mark IA. My shifter is a Hurst competition plus and I have
the Hurst switch made for it that triggers the lights when reverse is engaged.
I seem to remember from somewhere that the factory wiring harness may have
wires already in it for such lamps. If so, where do I access the power to the
switch and route it back to the bundle to get to the lights?
If there are not wires currently in the harness, where do people pick up the
power and how do they route it to the lamps? One possibility that occurs to me
is to tap into the line that feeds the fuel pump.
Any information on exactly where they should be located on the rear valence
under the fender would also be appreciated. BTW, the lamps I have are similar
the rectangular Wipacs, but are made by Lucas (same ones that were used on the
DB4's I believe).
Thanks,
Gene
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net
|