I must have pushed the wrong button or something, I'll try again.
Those little barrel standoffs are to put some space between the bumper
bracket and the body metal so as to not crush the body metal up against the
frame where the 1/2" bolt hole is. As you can see there is a little space
between the frame (where the 1/2" holes are) and the body panel that cover
the area. To attach the bumper I would put the bolts through the bumper
bracket than slide the barrels over the two bolts then (with a friend) bring
the bumper up together and tighten the bolts checking alignment as you
tighten.
By the way the front bumper do not have those standoffs.
Hope this helps
Jerry Christopherson
I took two pict. if you are interested.
-----Original Message-----
From: Rollright@aol.com
Sent: Monday, October 17, 2011 10:44 AM
To: tigers@Autox.Team.Net
Subject: [Tigers] barrel slug with hole in center
Hello,
To clarify on the bumper hardware, I got several replys indicating that I
misled some folks. In the spirit of clarity:
No not those pieces that are curved (to mate with bumper) on one side and
flat on the other.
This is a little barrel affair with a hole in the middle, 3/4" long, an
inch in diameter and a half inch hole in the center drilled through the 3/4
inch dimension.
Jim
_______________________________________________
tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/tigers/jcmc2006@suddenlink.net
_______________________________________________
tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|