Randy,
Don't waste your time on that old one, I believe that CAT wherhouse has this
part in stock,part # L9 @ $ 102.00, you could also check with Victoria
British, and see if they have..
Good Luck to you, and I really don't know another solution for you.
See Ya' Jan.....
-----Original Message-----
From: Randy Zimmermann <rzimm@hhh.umn.edu>
To: tigers@autox.team.net <tigers@autox.team.net>
Date: Monday, April 06, 1998 12:03 AM
Subject: Clutch Slave Cylinder
>Thanks to El Nino, spring has made an early arrival to Minnesota.
>This has allowed me to pick up on my restoration of B382002349 where
>I left off last fall. I'm at 2 years and counting but determined to
>get it up and running by the end of this summer. With a lot of luck,
>I'll get most of the interior work finished, too. That may be too
>optimistic. We'll see. SUNI III is my target.
>
>Over the weekend, I rebuilt the brake and clutch master cylinders.
>Both were in good shape and with a little honing both are going to be
>very functional. Unfortunately, I can't say the same thing for the
>clutch slave cylinder. The cylinder wall is badly pitted both deep
>inside and toward the outer end.
>
>Would anyone on the list have an extra slave cylinder that is in
>better shape that with a simple rebuild would be functional?
>
>I know I'm not looking at major bucks to buy a new one but I've
>pretty much exhausted my budget to get this far and I'm having to
>deal with these little unexpected suprises on the margin, so to
>speak.
>
>Any positive responses would be appreciated.
>
>Randy Zimmermann
>St. Paul, MN
>rzimm@hhh.umn.edu
>
>
|