team-thicko
[Top] [All Lists]

RE: dies

To: <dmeadow@juno.com>
Subject: RE: dies
From: "Wm. Severin Thompson" <wsthompson@thicko.com>
Date: Mon, 12 Dec 2005 07:44:13 -0600
I'm looking to lighten panels on a Sprite race car, so, the maximum metal
gauge is not too thick.

It seems to be far easier to lose 30lbs off my race car than off my fat
ass...

-----Original Message-----
From: owner-spridgets@autox.team.net [mailto:owner-spridgets@autox.team.net]
On Behalf Of dmeadow@juno.com
Sent: Monday, December 12, 2005 7:19 AM
To: wsthompson@thicko.com
Cc: team-thicko@autox.team.net; spridgets@autox.team.net
Subject: Re: dies

I've got a set I inherited from my grandfather, who was an electrical
engineer.  They were used for cutting various size holes in electrical
panels to insert instruments.  Perhaps an electrical supply place would
carry them.  You don't say how thick the metal is, though, and I wouldn't
expect these to be able to cut anything very thick.

They consist of two pieces, a cutting piece that fits on one side of the
metal with two sharp prongs, and a hollow piece that fits on the other
side.  There is a bolt that goes through them (you have to drill a pilot
hole) that is used to draw them together and cut the metal.

On Mon, 12 Dec 2005 06:59:40 -0600 "Wm. Severin Thompson"
<wsthompson@thicko.com> writes:
> Anyone know of a source for dies to punch holes in sheet metal for
> lightening?

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/team-thicko


<Prev in Thread] Current Thread [Next in Thread>
  • dies, Wm. Severin Thompson
    • RE: dies, Wm. Severin Thompson
    • RE: dies, Wm. Severin Thompson <=
    • Re: dies, Rick Fisk