spridgets
[Top] [All Lists]

Re: [Spridgets] Kent's Bugeye restoration

To: Kent McLean <kentmclean@comcast.net> WDDaaQYjn3ajXkvh8d0E4wyK29MSuo3l1RCyY2hyJxQRnCvwxsJoIsXC32Ai0uVEJYUwgDvCUzQ20B/mVF/Rxsnpt2MJ+OGjqofTcZpPjegTagtvDQ2NsQUa
Subject: Re: [Spridgets] Kent's Bugeye restoration
From: Rick Fisk via Spridgets <spridgets@autox.team.net>
Date: Mon, 14 Jun 2021 11:36:53 -0400
Authentication-results: chartermi.net; none a=r1s4udVvJQAa4S1PDOZ50w==:117 a=r1s4udVvJQAa4S1PDOZ50w==:17 a=IkcTkHD0fZMA:10 a=zOoktvdPAAAA:8 a=4ycV2vTZAAAA:8 a=60kqvnlRZ2cwVYcUIMsA:9 a=QEXdDO2ut3YA:10 a=m3MdUl94G8cA:10 a=GGGinmgZRQXmVEG1E52S:22 a=h1giTkCgq3OATUnuMCPB:22
Cc: spridgets@autox.team.net
Delivered-to: mharc@autox.team.net
Delivered-to: spridgets@autox.team.net
References: <09506D48-9BEA-4C23-A26F-5DC9C130CEE9@comcast.net>
Check the condition of the ground strap between the engine and chassis.  Might 
be all corroded up.

Rick

> On Jun 14, 2021, at 11:15 AM, Kent McLean via Spridgets 
> <spridgets@autox.team.net> wrote:
> 
> Engine Compression Check.
> The engine turns over by hand. I didn't have a 1.25" open end wrench for the 
> crank nut, and a socket won't clear the frame member, but I did have some 
> 1/8" bar stock that I welded into a wrench good enough to turn the crank.  I 
> did about 1/2 a revolution and it stopped. Hmmm.  The plugs were out, what's 
> stopping it? A frozen valve? I took of the valve cover to watch the vavle 
> action. A little more oomph on the wrench and it got by the stickiness. 2nd 
> revolution it stopped again, but less oomph was required to get by the 
> stoppage. After that, it turned pretty easily. OK, now it's free.
> 
> Next step was to do a compression check. I took out the old battery, dropped 
> in a new, charged Optima Red (too early in the process to get it, but if I 
> keep it on a battery tender, it should do OK until I need it), and hooked up 
> the battery cables. Moment of truth: put in the key, turned it, pulled out 
> the starter pull and - nada. The pull didn't pull enough to activate the 
> solenoid. No worries, I just pulled on the other end of the cable at the 
> solenoid. Rr. Rrr. Doesn't seem to be enough juice getting to the starter to 
> spin the engine. Arrrgh!  Time to remove, clean, and reattach the battery 
> cables, and hope the starter is OK.
> 
> ------------------------
> 
> spridgets@autox.team.net
> 
> Donate: http://www.team.net/donate.html
> Suggested annual donation: $12.75
> 
> Archive: http://www.team.net/pipermail/spridgets  
> http://autox.team.net/archive
> 
> Unsubscribe/Manage: 
> http://autox.team.net/mailman/options/spridgets/refisk@chartermi.net

------------------------

spridgets@autox.team.net

Donate: http://www.team.net/donate.html
Suggested annual donation: $12.75

Archive: http://www.team.net/pipermail/spridgets  http://autox.team.net/archive

Unsubscribe/Manage: 
http://autox.team.net/mailman/options/spridgets/mharc@autox.team.net
<Prev in Thread] Current Thread [Next in Thread>