Unless a PO put in a much needed relay, it's just a game of follow the wires.
Probably the bullet connector up front that splits the two high beam wires.
(B/W?)
Glen
> On Nov 26, 2018, at 10:50 PM, Andy Webster via Spridgets
> <spridgets@autox.team.net> wrote:
>
> Greetings folks,
> I haven't had hi-beams working for quite some time..and problem was first
> noticed after an extended period of lay-up.
>
> I pulled off and tested the dip switch yesterday, which appears to work fine,
> so I guess its a poor connection/earth somewhere.
>
> Does anyone know some likely places to look for the source of the issue? or
> is it just a matter of following wires?
> is there meant to be a relay of any sort in there, or does full current go
> through the switch? They're just the standard sealed beam units.
>
> I've not had much to do with the lights before.. as they just worked (insert
> Lucas joke here) oddly enough (or perhaps here).
>
> cheers
> Andy\
------------------------
spridgets@autox.team.net
Archive: http://www.team.net/pipermail/spridgets
|