I have a 1979 MG Midget with lucas alternator. Where is the voltage
regulator located. ...bill in corvallis
========================================================
-----Original Message-----
From: spridgets-bounces at autox.team.net
[mailto:spridgets-bounces at autox.team.net] On Behalf Of Frank Clarici
Sent: Tuesday, September 28, 2010 6:20 PM
To: twobees at sprynet.com
Cc: Spridgets Digest; Vintage Racing Digest; MG Digest;
MGVR at yahoogroups.com; bugeye at yahoogroups.com
Subject: Re: [Spridgets] Change from Generator to 1-wire Alternator
On 9/28/2010 8:52 PM, Norm 2Bs wrote:
> HELP! My old crew and auto electrical expert, now racer himself, is still
> in Connecticut (Hi, Jim)& I'm stumped by this conversion.
> Here's what I have on the regulator terminals:
> A1 - 2 brown/blue wires
> A - 1 brown/white
> F - 1 yellow/green
> D - 2 yellow
> E - 2 black
Norm
On the small jap 1 wire alternators, take the large "B" (battery)
terminal from the alt and hook it to the 3 large wires at the regulator.
That would be the wires from A1, A, & D on the regulator.
If you want the ignition light to work, hook the small yellow wire from
D and the yellow/green wire from F together, the small wire (field) at
what was the generator now goes to one of the small terminals on the
alternator, 1 is usually a tickler terminal, the other works the ign light.
If it does not light on the first terminal, don't worry, it will not fry
anything in the alternator, try the 2nd terminal.
Most jap alts have a "T" shaped plug terminal, it is usually the
vertical let of the "T" that works the ign lamp.
Not always but on all Mitsubitchi alts.
If you want to keep the regulator for looks, gut it internally except
for the connector from A1 & A, those 2 terminals are already hooked
together inside the regulator. Run a jumper inside from D to A now all 3
are hooked together, A, A1, & D, keep the wires as they were except for
the small one on terminal D, connect that wire to the original wire on
terminal F so the ign lamp works.
Just keep the black wire on E (earth) as it now has no purpose.
If your regulator is still good, do NOT gut it, find a dead one to gut
and just solder a stout wire inside from A to D.
--
Frank Clarici
Toms River, NJ
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/spridgets/corvallis at peoplepc.com
|