I don't remember what the type of drill bit was called, but I used a bit that
is easily available at Home Depot and Lowes--a metal drilling bit with a small
sharp protruding point on it.B After I drilled I used an air chisel between
the floorpan and the body to break whatever minimal attachment remained.B
Worked great!
--David C.
"FREE ENES!"
----- Original Message -----
From: "Guy R Day" <grday@btinternet.com>
To: "Linda Grunthaner" <grunthaner@gmail.com>, "Billy Zoom"
<billyzoom@billyzoom.com>
Cc: spridgets@autox.team.net, domanicoj@comcast.net
Sent: Thursday, October 28, 2010 8:33:06 AM
Subject: Re: [Spridgets] Hints on floorpan replacement?
Couple of older guys I know use a sharp thin bladed chisel (similar to a
builders 'bolster chisel') and hammer that between the metal sheets welded
together. B Angle it to cut the 'scrap' metal away but it still leaves a
stretched metal area on the 'good' side that needs shrinking. B What it does
do is leave a line of thicker metal dots located where the manufacturer left
them and you re-spot weld back through them. B If done with the expertise
these guys had in their hands you couldn't tell between origional and their
spot weld panels.
I have never been able to achieve similar results.
Guy R Day
----- Original Message -----
From: "Linda Grunthaner" <>
To: "Billy Zoom" <>
Cc: <>
Sent: Thursday, October 28, 2010 11:30 AM
Subject: Re: [Spridgets] Hints on floorpan replacement?
> Is this what your talking about? It looks difficult is there anything else
> better to remove spot welds?
>
http://www.harborfreight.com/3-8-eighth-inch-double-sided-rotary-spot-weld-cu
tter-95343.html
>
> Lin
>
> On Tue, Oct 26, 2010 at 9:02 PM, Billy Zoom <> wrote:
>
>> Once the car's upside down, it's pretty simple. Harbor Freight sells
>> spotweld cutters that are knockoffs of the Blair. Buy a few.
>> BZ
>> _______________________________________________
Suggested annual donation B $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/spridgets/dlancer7676@comcast.net
_______________________________________________
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|