HalPush the piston of the slave fully into the bore then adjust the nut until
there is about 1/8" slop in the linkage when the yoke is just touching the
fingers. This should set it perfectly.BillM
> Date: Sat, 23 Oct 2010 06:58:59 -0700
> From: frog.aye@gmail.com
> To: spridgets@autox.team.net
> Subject: [Spridgets] Slave cylinder adjustment
>
> It looks like it will be a PITA to adjust the Morriservice adjustable
> pushrod on my slave cylinder once the assembly is in the car. Here's what
I
> have:
> Morriservice 5-speed adapter, using a 1275 slave cylinder and datsun
> clutch. The release fork moves against the retractor spring then becomes
> almost impossible to move by hand), I assume this is when the t.o. bearing
> connects with the fingers on the pressure plate. Any suggestions as to how
> to set the adjustable pushrod before dropping the thing in the car?
> Hal
> _______________________________________________
>
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/spridgets/billmasq@hotmail.com
_______________________________________________
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|