I have a rubber bumper registered as a 1979.
Support piece measures 12-inches plus 1/16-inch
...bill in corvallis
===============================================
-----Original Message-----
From: spridgets-bounces@autox.team.net
[mailto:spridgets-bounces@autox.team.net] On Behalf Of Frank Clarici
Sent: Sunday, October 03, 2010 12:27 PM
To: Spridgets
Subject: [Spridgets] measurement needed
Square Sprite of Midget.
I need to know how long the center support from the bottom of the front
apron to the underside of the spot where the bonnet latches.
My $50 Midget project does not have this piece.
I can make it easy enough if I knew how long it was.
If you have a car with the grill out, could someone please measure the
center support piece for me.
Thanks.
I have a 67 with that piece but I hate to remove the grille just to see
how long it is.
--
Frank Clarici
Toms River, NJ
_______________________________________________
_______________________________________________
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|