I am at the point in my engine rebuild of putting on the distribuor.B I will
not use the original dist. but a new Pertronix.B And I did not mark where the
old oneB was set before disassembly (too much planning for meB ; ).B With
the first cylinder set at TDC, where should I set the new distributor?B Close
is good enough for me to start with.
_______________________________________________
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|