Make sure that #1 fires when it's supposed to; close to TDC and both valves
are closed on the cylinder. Make sure wiring sequence is correct. Are valves
adjusted? ...bill in corvallis
=============================================
-----Original Message-----
From: spridgets-bounces@autox.team.net
[mailto:spridgets-bounces@autox.team.net] On Behalf Of Jess Power
Sent: Thursday, May 06, 2010 2:48 PM
To: spridgets@autox.team.net
Subject: [Spridgets] bugeye won't start
Point gap set, spark plugs set. Getting a spark from each distributor
wire. Motor turns over well. Will not start. Will check timing next. Any
suggestions? Motor has not run since rebuild(1275cc)
_______________________________________________
_______________________________________________
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|