John,
Thanks for the link. I had a look and, wow, there's a lot of different types.
The holes are less than 3/8" diam. and are not slotted. But there are 'blind'
in the semse that I can't get behind the sheet metal ;-(
Any recommendation as to which one I should use for use in sheet metal?
Dave G.
>
>From: fastvee <fastvee@yahoo.com>
>
>
>If the hole is not slotted, and is 3/8" or less in diameter, you can use nut
>inserts. There is an insertion tool required, but I have always made my own
>tool for the smaller sizes. They hold very well when installed correctly.
>http://www.mcmaster.com/#threaded-inserts/=67ripo
_______________________________________________
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|