1 newton/square millimeter = 145.037 738 007 pound/square inch
psi divided by 145(ish) will be N/mm2
Try http://www.translatorscafe.com/cafe/units-converter/ for other
conversions
----- Original Message -----
From: <WeslakeMonza1330@aol.com>
To: <derf247@gmail.com>
Cc: <spridgets@autox.team.net>
Sent: Friday, December 25, 2009 11:58 PM
Subject: Re: [Spridgets] Trunnion bolt - 2A 4028 - NEW MANUFACTURE in
stainless steel ...
>I have to do a calculation to convert psi to N/mm2 to answer that
> question. When I do I'll post the answer.
>
> Regards
>
>
> In a message dated 23/12/2009 16:17:53 GMT Standard Time,
> derf247@gmail.com
> writes:
>
> Are they going to make any in Grade 8 carbon steel? Is stainless
> better in that application?
> Stainless is great until you mate it with carbon steel. Then Galvanic
> action action seems to attack the junction more than if similar steels
> are used.
> I'm sure you can find a grade of stainless that will be superior but
> is the extra cost worth the gains?
> Just my observations. (I'm just sayin.)
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as grday@btinternet.com
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|