--- On Wed, 11/11/09, Peter Caldwell <peter@nosimport.com> wrote:
> How are y'all accomplishing crankcase
> venting with a side draught Weber on a 1275?
For the intake Cannon manifold, I drilled and tapped a pipe thread where the
flat is (the spot for Mini brake booster, I think). I did not run a balance
tube and 1&2 were always a bit lean. I'd add a balance tube if I were doing it
again. I used a chrysler K-car PCV valve. For Maniflow intake, I'm not using
one (successfully) but I'd weld in a cross tube with a hose barb to go to a PCV
valve.
Ron
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|