Victoria British is OK, but you should be reasonably knowledgeable about the
parts you're ordering. Those on the phones are not necessarily car folks,
so you should keep that in mind.
My humorous experience many years ago was when they ran an ad for 3.7 dif.
"pumpkins". So I ordered one. I had no idea they came in sizes as 0.20 0r
0.40 oversize until I was asked that after stating my order!! I think I got
std.!
Later, Paul A
----- Original Message -----
From: "Billy Zoom" <billyzoom@billyzoom.com>
To: <andrewpayne@intrex.net>; "Spridgets" <spridgets@autox.team.net>
Sent: Monday, September 28, 2009 7:37 PM
Subject: Re: [Spridgets] Hinton floor boards
> > is there a difference between Moss and VB quality?
> I depends on the piece. I got repair panels from Moss...left side was
> British and fit well, right side was Asian and unusable. Moss offered to
> refund my money, but couldn't get a decent part. I ended up fabricating
one
> using the other side as a pattern. In other words, Moss will give a
refund,
> but they make no promises that anything will be usable.
> I've had MUCH better luck with Victoria British, but I get flamed by
certain
> list members every time I say so. I haven't gotten anything that was crap
> from VB.
> BZ
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as pasgeirsson@worldnet.att.net
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|