I think hole #2 was unused and filled with a blanking grommet (at least for US
cars)
Need to do more research to be certain...
----- Original Message -----
From: "Frank" <spritenut@comcast.net>
To: "Dean Hedin" <dlh2001@comcast.net>
Cc: "Spridgets" <spridgets@autox.team.net>
Sent: Monday, July 27, 2009 11:28 PM
Subject: Re: [Spridgets] Bugey heater blower, it's harness, and the firewall.
> Dean Hedin wrote:
>>
>>
>> Question #2 Is the above diagram correct?
>>
>> Question #3 If the above diagram is wrong, then what goes through hole
>> number two?
>> _______________________________________________
> I think hole #2 is for the heater cable, hole 6 is for the battery wire
> or maybe the starter cable, then hole 4 is for the battery wire.
> I am not positive on these holes from the picture but the cables use the
> straightest line from pull knob to device except the MKII which for some
> reason crossed the choke and starter cables
> There is no heater wire harness, is comes out of the main harness near
> the fuse box and hooks up to the heater blower.
> The ground goes to the single leg up near the firewall not under the
> lower blower bolts. The heater hot wire is (usually) green with a
> yellow stripe.
>
> --
> Frank Clarici
> Toms River, NJ
> My own Fleet of Sprites
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|