My heater blower has two wires.
One wire has a lucas bullet connector, and the other has eyelet (presumably a
ground to be connected to a nearby 1/4 x 28 bolt).
These connectors appear to be original.
Question #1: Which nearby bolt did the eyelet go to?
My next problem is when I look at this diagram:
http://www.gerardsgarage.com/Garage/Tech/Cables_wires_lo2.htm
It says that hole (numbered 2) in the firewall is for the heater motor harness.
What harness? As far as I can tell, the proper wire from the heater switch
goes down through the main woven harness and comes out
near the connector that goes to the hi/lo beam harness right near the heater.
Question #2 Is the above diagram correct?
Question #3 If the above diagram is wrong, then what goes through hole number
two?
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|