Well put.
And I still believe that the silicon brake fluids are not hydroscopic.
Thus moisture that will get in there, sinks to the low places and rusts
whatever it is in contact with; sooner than with DOT 3 fluid. ...bill in
oregon
=================================================
-----Original Message-----
From: GUY DAY [mailto:grday@btinternet.com]
Sent: Sunday, July 19, 2009 4:06 AM
To: corvallis@peoplepc.com
Subject: Re: [Spridgets] Racer type question..
I'm with Bill below but I would add one of the reasons for any water build
up (It comes IN the fluid hydroscopically) is not changing the fluid every
couple of years. Old fluid is old because it has absorbed airborne moisture
until it concentrates sufficiently to distil from the fluid as puddles in
the line. The moisture content turning to a gas by heating is the reason
for true brake fade - as opposed to burning the braking material.
I don't particularly want to open up another 'can of worms' but IF you are
having a new braking system (that is everything in the brake system) and one
that is not contaminated with ordinary braking fluid it is a good time to
change over to silicon fluid. If it is just new calipers and nothing else
don't do it. If the seals have been lubricated with ordinary fluid prior to
assembly, don't do it.
Guy R Day
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|