Not pre-68, just 68 only. But you can add the tenax fastener to the 69-79
top if you find a deal on one.
David R.
----- Original Message -----
From: "Mark A. O'Neil" <mark.a.oneil@dartmouth.edu>
To: <spridgets@autox.team.net>
Sent: Wednesday, March 11, 2009 4:00 PM
Subject: Re: [Spridgets] Tenax Posts?
> Hey,
>
> Thanks to everyone who has replied - the consensus seems to be:
> 1) I'm not crazy for wanting to do this
> 2) I can get the posts through vendors ( I had missed them in the
> catalogs ) or boat/upholstery shops
> and
> 3) the machine screw post through the trim finish cap is the way to go
> as the sheet metal one would probably eventually pull out.
>
> Now one more question:
>
> The top needs replaced too, so do I get an 8 tenax (pre-68?) top and
> just install the posts through the trim finish or get a 6 tenax top
> and fit the missing two posts and pulls?
>
> Cheers,
> -m
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as davriker@nwi.net
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
--------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.0.237 / Virus Database: 270.11.10/1995 - Release Date: 03/11/09
08:28:00
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|