I think I found a good site to clean up my carb. I think Frank was right as
I ran out of gas the dirt clogged the needle assembly check out this page.
http://www.ccgtvonline.com/Resources/S.U.Carb.pdf
Lin
On Sat, Aug 9, 2008 at 12:46 PM, Linda Grunthaner <grunthaner@gmail.com>wrote:
> I found the message on my carb see below:
>
> List & Frank,
> Frank you were right about my carburetor the needle on one float assembly
> keeps sticking to the top of the housing, I can free it with compressed air
> but then it sticks up again. How can I get that to slide up and down freely
> without buying a new set of needles right away (I am guessing that I am
> using the proper terminology correct me if I'm wrong)? I see in the Moss
> catalog they sell a needle & seat set but they also list a Grose Jet, as a
> superior replacement. What is your opinion as well as the group's opinion?
> Thanks in advance & sorry if I haven't been keeping up with the list mail,
> Linda
>
> 62 California Sprite "Pinky"
> www.freewebs.com/lgrunthaner
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|