That sounds correct. With a couple of exceptions the Sprites were
all ASA bolts and screws.
Bob Kitterer
1960 Austin Healey Sprite (Mk IV in disguise)
1966 Austin Healey Sprite Mk III (Trevor) - still in boxes
2000 Miata Special Edition
On Jun 12, 2008, at 6:47 AM, Brashear, Jack, N wrote:
> Hey Marc, I use 1/4-28. Don't know if that's original or not but
> that's
> what I've been using on A series engines for over 40 years. Just
> remember that there are (I think) two different lengths. The
> longer is
> for the thru-tapped holes and the shorter is for the blind-tapped
> holes.
> Seems like the longer were originally 5/8" long and they are kinda
> tough
> to find at your corner hardware store. Sooooo, I use 3/4" and just
> live
> with it.
> Jack
>
> -----Original Message-----
> From: spridgets-bounces+jnbrashear=garverengineers.com@autox.team.net
> [mailto:spridgets-bounces
> +jnbrashear=garverengineers.com@autox.team.net]
> On Behalf Of Marc
> Sent: Wednesday, June 11, 2008 11:43 PM
> To: Spridgets
> Subject: [Spridgets] oil pan bolt size
>
> Anyone happen to know the proper size for oil pan bolts? Hate to buy a
> whole set just to get one...
>
> --
>
> Marc
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as bkitterer@mac.com
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|